for Macintosh

If the printing position and the cutting position are offset as shown in the figure below, you can correct the issue by adjusting the cutting position.

CROP - L/W Values

Input range: - 25 mm to 25 mm

To move the cutting line 0.5 mm to the left → Enter the W value

 

To move the cutting line 0.5 mm down → Enter the L value

 

To move the cutting line 0.7mm up and 0.5 mm to the right → Enter both W and L values

 

1. Set the CROP - L value

  1. Press several times to display the screen shown in the figure.

     

  2. Press several times.

     

  3. Press .

     

  4. Press several times to display the screen shown in the figure.

    The screen below is displayed.

  5. Press twice.

    The screen below is displayed. First enter the CROP - L value.

  6. Press to enter the values.

    Refer to the section above titled "CROP - L/W Values" to enter the values.

     

  7. Press .

    The screen below is displayed.

     

    2. Set the CROP - W value

  1. Press .

    The screen below is displayed. Enter the CROP - W value.

  2. Press .

     

  3. Press to enter the values.

     

  4. Press .

    When you have finished, press the key to go back to the screen in the figure.

  5. Send cutting data.

    Perform cutting again and check the cutting position.

     

 Back