Performing Cutting Only/Printing and Cutting Continuously

1. Double-click or .
   The [Queue A (B) Properties] window appears.
2. Click .
3. From the [Operation Mode] list box, select one of the following settings.

   To perform cutting only

   Select [Cut Only].

   To perform printing and cutting continuously

   Select [Print & Cut].
4. Configure the following settings if necessary.

   To cut along all paths drawn in vector format

   Select [Cut All Paths]. All paths drawn in vector format are recognized as cut lines regardless of the use of the spot color (CutContour).

   To cut along the outline of the image regardless of cut lines

   Select [Cut Image Boundaries].

   To rewind the media to the original position (position before cutting) after cutting

   Select [Return to Origin After Cut].

   To configure the cutting conditions of your printer

   Select [Enable Advanced Settings] to configure the cutting conditions.
   Configuring the Cutting Conditions
5. Configure other settings such as media setting if necessary, and then click [OK].
   Note
   • If cut lines are drawn along the boundaries of the image in an EPS file, follow the procedure below before adding the EPS file to the job list. Otherwise, some outlines may not be cut properly.
   1. In [Queue Properties] window, click.
   2. Enter the value of 0.35 mm or more in [Margin] in [EPS].
      • Entering the value less than 0.35 mm does not add margins.
      • If you scale the image in the [Queue Properties] or [Job Settings] window, the size of margin is also scaled.
        If you add the job to the job list, the margins are automatically added along the boundaries of the image according to the [Margin] setting.
6. Add the job containing cut lines to the job list, and then start printing.
   Basic Printing Operations
   

   If you selected [Cut Only]

   Cutting starts along the cut lines of the selected job.

   If you selected [Print & Cut]

   Printing starts first. After finishing printing, cutting starts automatically.

• You can also configure these settings (except [Cut All Paths]) in the [Job Settings] window.
• If you require extra dry time to dry the printing surface before cutting, configure the setting in [Dry Time].
  Configuring the Printer Control Settings