Using Roll Material
CAUTION
Never load media that weighs over 40 kg (88.19 lb.).
The machine may fail to withstand the weight, causing the machine to tip over or the material to fall.
Using Flat Material
If flat material is used, it must be at least 60 mm longer than the vertical size of the cutting data. This is the length required for the pinch rollers to feed out the material to the front and rear.
Refer to the figure below and ensure that there are sufficient margins at the front and rear of the material.
 |
1: 30 mm or more 2: 30 mm or more 3: Pinch roller 4: Material-feed direction |
Using Material with Perforations for Sprocket Feed
Sprocket-fed material has perforations along each edge. If the pinch rollers are positioned over the perforations, the material cannot be fed correctly.
Load the material as shown in the figure.
