Bugfixes in hyperDENT® Compact NEW V9.4.3

•Bugfix: Occlusal side engravings were not processed as expected. In addition, some problems with the insertion direction of tags were fixed.

•Bugfix: Fixed crash of hD when starting the calculation. Caused by a failed boundary calculation of a part.

•Bugfix: The inqueue.exe has been optimized, in some cases it used up all the RAM.

•Bugfix: Failing Emergence protect surface creation led to incorrect tool path.

•Bugfix: Partial finishing emergence profile - bad gouging near the abutment base in preforms.

•Bugfix: Fixed an issue with occlusal machining of screw channels with tapered/rounded screw seats.

•Bugfix: Solved issue with Bosnian language set in Windows.

•Bugfix: "Slot roughing" has been optimized.

•Bugfix: After the main direction was set, turning to the different views did not work property.

•Improvement: If the allowance for engraving was negative, there was a possibility of potential fixture-violation.

•Improvement: It is possible to move the complete fixture.

•Improvement: Finishing inside inlay/onlay is also available for the part type Secondary telescope bridge.

•Improvement: Load part now also shows ungrouped materials as expected.

•Improvement: Optimized behavior for exchange geometries used for angled screw channels.

oNow the screw channel will remain angled if the exchange geometry doesn't offer any deflection values/angles.

oScrew channel designer is not available of the exchange geometries has no deflection values/angles.