|
Part tilt
|
Setting of the preferred tilt axis for automatic part tilting when the part is loaded. The maximum tilt angle is defined in [Settings > Machining > Machines > Axis limitations].
To use the auto tilt part function, you must first enable this setting in [Settings > General > Load wizard].
|
|
Inclination axes
|
|
|
Only X-axis
|
Inclination in the X-axis only; suitable for 4-axis machines.
|
|
Prefer X-axis
|
Inclination in both axes; the X-axis is preferred.
|
|
Only Y-axis
|
Inclination in Y-axis only; suitable for 4-axis machines.
|
|
Prefer Y-axis
|
Inclination in both axes; the Y-axis is preferred.
|
|
Any
|
Inclination in both axes without preference.
|
|
Calculate in NC coordinates
|
|
|
Yes
|
Perform calculation for identical NC coordinate system. Required for processing NC data with hyperDENT Calculation Merge.
|
|
No
|
Use the existing coordinate system. It is not possible to merge different NC data with hyperDENT Calculation Merge.
|
|
Tool change optimization
|
Holder-specific adjustment option
|
|
General settings
Yes
No
|
|
|
Enable open fixture functionality
|
With open holders, the milling boundary is extended at the opening. This enables lateral processing such as finishing interdental areas with a tilt of up to 90 degrees relative to the main axis.
|
|
No
|
Default. Behavior as with closed holders
|
|
Yes
|
The milling boundary is extended.
|
|
Rotation axis
|
Preferred rotation axis for display on the screen.
|
|
Connector behavior
|
|
|
Create traverses
|
|
|
Yes
|
If overlapping milling area boundaries exist and the connectors are created using the “take ALL parts into account” button, a traverse is created between parts.
|
|
Object nesting
|
Settings for the automatic placement of parts in the blank (auto nesting). Further information --> “Load part” > “Place part automatically – Autonesting.”
|
|
Use automatic nesting.
|
|
|
Yes
|
Load the part and place it automatically.
|
|
No
|
Load the part. The part must be placed manually.
|
|
Choose nesting direction
|
Arrangement of the parts according to the order of placement.
|
|
|
from inside to outside
from outside to inside
from left to right
from right to left
from down to top
from top to down
|
|
Position of first part / zero point
|
The position depends on the selected nesting direction. Useful for block-type material.
|
|
|
Top left
Top middle
Top right
Middle left
Middle right
Low left
Low middle
Low right
|
|
Performance
|
Selection of the placement mode according to performance criteria:
Super speed - low precise
High speed - medium precise
Medium speed - high precise
Low speed - super precise
|
|
Allow overlapping milling boundaries
|
Specification of the milling boundary.
|
|
Yes
|
Overlap milling boundaries, save material.
|
|
No
|
No overlapping milling boundaries.
|
|
Connectors adding to part
|
|
|
Yes
|
Include connectors into nesting calculation.
|
|
No
|
Connectors are not included into nesting calculation
|
|
Screwchannel adding to part
|
|
|
Yes
|
Include the screw channel into nesting calculation.
|
|
No
|
The screw channel is not included into nesting calculation.
|
|
Connectors offset [mm]
|
|
Fixtures
