For 3D profile finishing pocket mode (bridges cavity side), 5X profile finishing pocket mode (bridges cavity side)

Add. outer Z-Level finishing

Yes

Recommendation is “Yes” since the profile finishing cycle generally does not create workable milling tracks in steep areas. With this cycle, all areas are machined up to the Z-level boundary area (general boundary area for the machining of the occlusal and cavity side).

Advantage

Cycle is calculated quickly. Efficient milling tracks are created that also exhibit relatively few lifting movements.

Disadvantage

The steep areas in the interdental space are not optimally machined.

1) Yes: Add outer Z-level finishing is enabled

2) No: Add outer Z-level finishing is disabled