Slope dependent machining
|
|
Yes
|
Slope dependent machining so that the tool is lifted off the part less often: Yes/No
|
1) Yes: Slope dependent machining is enabled.
2) No: Slope dependent machining is disabled.
|
Machining method
|
Limit machining in a job to steep or flat machining areas.
Only available for the “Finishing inlay/onlay” machining method.
|
Split angle
|
Degrees
Angle for separation into steep and flat machining areas.
Only available for the “Finishing inlay/onlay” machining method.
|
Step down
|
mm
The step down in steep areas can be set regardless of the horizontal step.
The groove depth must be harmonized with the length of the cutting part of the tool. The depth step is repeated until the part is reached.
|
Work order flat areas
|
Pathway of milling paths on the occlusal side.
|
From inside to outside
|
|
From outside to inside
|
|
Strategy steep areas
|
|
Oneway
|
Machining in synchronization only: higher surface quality, longer processing time.
|
Zigzag
|
Machining up and down: shorter processing time, lower surface quality.
|
