| About the Blades and Materials |
Using a Variety of Materials
- Using flat material
If a flat material is used, the material must be at least 70 mm longer than the vertical size in the cutting data. This is the length required for the pinch rollers to feed out the material to the front and rear.
Refer to the figure below and ensure margins at the front and rear of the material.
- Using Roll Material
• Be sure to use the roller base to load the material. If you are not using the roller base, cut the required length of material before loading the material.
• Refer to Checking Material Feed to check material before cutting.
• If SELECT SHEET is set to EDGE and the material is loaded, the area from the top edge of the material to 25 mm is reserved for the margin.
- Using Material with Perforations for Sprocket Feed
Sprocket-fed material has perforations along each edge. If the pinch rollers are positioned over the perforations, the material cannot be fed correctly. Load the material as in the figure.
