Checking Material Feed

If you are using a roll material or flat material whose length is more than 1.6 meters, check that the material can be fed correctly before cutting.

1. Press the MENU key several times to display the screen in the figure.
   
   
   
   Press the key.
   
   
   
   
2. Press the key.
   Press the key.
   
   
   
   
3. Press the key.
   Press the and keys to set the value for the required length of the material.
   
   
   
   It is a good idea to set a value that is about 0.2 meters longer than the required material length.
   
   
4. Press the ENTER key to enable the setting.
   The set length of the material moves out to the front, then is immediately pulled back and taken up again.
   
   
5. Press the MENU key to go back to the screen in the figure.
   
   
   
   

If the material comes loose from the pinch rollers, press the PAUSE key to stop operation. Then reload the material, starting over from the beginning.

Be sure to check the material feed. If you start cutting without checking the material feed, correct cutting results may not be obtained. In the worst case, it may cause an error or malfunction or damage to the material.

Reference: AREA