| About the Blades and Materials |
Cutting AreaThe cutting area along the horizontal plane (the direction in which the cutting carriage moves) is determined by the position of the pinch rollers.
The cutting area spans the length between the two rollers, minus approximately 1 mm on each side.
|
Type of specified sheet
|
Cutting area
|
| ROLL or EDGE | <Width>: Length between the two pinch rollers minus approximately
1 mm <Length>: Approx. 24998 mm |
| PIECE | <Width>: Length between the two pinch rollers minus approximately
1 mm <Length>: Detected length (*1) |
*1: If the detected length is 1600 mm or more, the machine
determines the material to be ROLL.
The length of the cutting area is set approximately 24998 mm.
However, the display does not show the length.
