The order of the cuts for bridges is always from the outside working inward.
|
Connectors
|
Selection of connectors that are to be machined with this job.
|
Connectors to reduce
|
Only for connectors that are to be reduced: Cut setting < 100%.
|
Connectors to cut
|
Only for connectors that are to be cut:
Cut setting = 100%.
|
All connectors
|
|
Side
|
Occlusal side / cavity side
Predefined (primary) side for machining.
Cuts can be set from both sides. The required offset to the equator (viewed in the machining direction) is generated automatically.
|
From both sides
|
|
Yes
|
Creates cuts from the occlusal and cavity sides.
Caution! Do not place cuts from the cavity side into undercut areas.
|
No
|
Only cuts from the occlusal or cavity side.
|
Reduce percentage
|
0 ... 100%
Specifies how much of the predefined cut depth is to be machined during connector reduction: --> [Milling cut] > [Cut depth] setting.
|
Allowance part
|
mm
Additional distance (1) to the part for the cut.
|
Contour parallel
|
|
Yes
|
The cut follows the outline of the part.
|
Additional cutting height
|
mm
Defines the start of the machining above the connectors in order to take into account the allowance after roughing.
|
Rectangular box
|
For shortening the milling paths/cutting time at the connector.
|
Yes
|
When calculating the milling path, a rectangular box is placed around the connector.
|
No
|
The milling path is calculated directly on the connector.
|
NC text (sequence)
|
Free NC texts for the entire connector processing. For the use of part catchers. Extend before the first connector, retract after the last connector.
|
