Bugfixes in hyperDENT® Compact NEW V9.4.2

Anfang  Zurück  Weiter

 

 

•Bugfix: Roughing machining stays within the boundary.

 

•Bugfix: Tags can no longer be machined from the wrong side.

 

•Bugfix: The Job "Roughing cavity side/3D Trochoidal outer above connector" the start position is fixed outside the material.

 

•Bugfix: Feature curves are no longer cached as this caused problems.

 

•Bugfix: The job "Roughing cavity side" can now be added to the part types secondary telescope and secondary telescope bridge.

 

•Bugfix: In the job "Finishing occlusal side:3D Equidistant finishing flow" the collision avoidance was optimized.

 

•Bugfix: In the job " Finishing inside abutmentbase - Z-level finishing", the selection "Use cap spec. direction" is now considered.

 

•Improvement: The fixture CS can be moved in X/Y/Z relative to the NCS.

 

•Improvement: The job "Slot roughing part finishing" now supports both milling directions.

 

•Improvement: Optimization of the screw channel design mode.

 

oIf the design mode cannot be started, this is indicated by a message.

 

oReset has been revised so that exchange geometries are now also taken into account.

 

•Improvement: Optimization in the job " Segmented 3D Equidistant", here screwchannel caps and pocket caps are better recognized.

 

•Improvement: Better calculation times for the job "Finishing occlusal 4x Turn (4x Turn milling).

 

•Improvement: Interface walls are better identified.

 

•Improvement: Exchange geometries are now rotated according to the added values.

 

•Improvement: Better slot selection for multiblank fixtures, especially with the work for "save remaining blank".

 

•Improvement: "Load part" has been optimized so that there are fewer system crashes when reading the metadata.

 

•Improvement: Exocad metadata of the part type bitesplint, are now read correctly.

 

•Improvement: Quick way to expand or collapse all millstrategies.

 

•Improvement: New parameter in the job restmachining any side - autorest 3x/5x, for better surface quality of prefab machining.

 

•Improvement: "Finishing emergence profile": Limit the tools available for turnmilling to only ballnosed tools.