Set this setting to "ON" to feed out the material automatically during cutting. While this setting is enabled, when cutting data is sent from the computer, cutting is performed every 1 meter after the material has automatically been fed forward (depending on the data, the material may be fed out more than 1 m, for example if the next movement point is more than 1 m back).
If material has already been fed out using the AREA function, the material will not be fed out automatically until the length of material that was fed out using the AREA function is reached, even if PRE-FEED is set to "ON."

*This function is only enabled when the material type has been set to "ROLL."

Procedure

Make sure that the material is load to the machine.
  1. Press several times to display the screen shown in the figure.

     

  2. Press several times to display the screen shown in the figure.

     

  3. Press .

  4. Press several times to display the screen shown in the figure.

  5. Press .

     

  6. Press to select ON or OFF.
    Setting feed speed

    When the figure above is displayed, press the key twice to display the figure below.

    Press to set the speed.

    Setting Range: 1 to 10

    Press .

  7. Press .

    When you have finished, press the key to go back to the screen in the figure.

Back Next