If the material was not cut correctly (for example, if the result of the cutting test was that two shapes peeled off together), change the blade force.

Procedure

  1. Check that the PEN FORCE slider is at the center position (at "0" on the scale).

     

  2. Press ［CUT CONFIG］ to display the following screen.

     

  3. Press [] to display the following screen.

     

  4. Press ［］ to display the following screen.

     

  5. Press [] and [] to change the blade force.

     

  6. Press [ENTER] to select the setting.

     

  7. Press [MENU] to return to the original screen.

     

  8. Fine-tuning the Blade Force

    After you set the blade force using the FORCE menu, you can further fine-tune the blade force using the PEN FORCE slider. Use this operation when you want to make the blade force slightly larger or smaller than the setting made using the menu.

    Adjustable range: ±Approximately 30 gf

    * This value is intended only as a rough guide. The accuracy of this value is not guaranteed.