For all Cycles Machining Occlusal Side

Occlusal tilt with undercut machining for 3+1/3+2 machines with settings for the following machining parameters: Rotation axis Multi-axis machining Differential angle for finishing The part is rotated in the plus and in a minus direction depending on the rotation axis entered, and the toolpath is recalculated. Up to 4 jobs are created.
Use occlusal direction
Yes	Required if --> “Occlusal insertion direction” has been set so that milling also takes place.
No	For machining without “Occlusal insertion direction.”
Multi-axis machining
Yes	Perform undercut machining on 3+1 machines.
No	Do not perform undercut machining on 3+1 machines.
Add. angle	Differential angle for finishing.
Rotation axis	Rotation axis for the tilt.
X+Y	Rotation axes for 3+2/5X machines.
X	X rotation axis for 3+1 machines.
Y	Y rotation axis for 3+1 machines.
The milling process takes place with the corresponding tilt if the axis entered is permissible for the machine being used. It is very useful, e.g., for angled abutments, to avoid unmachined areas in undercuts. The function is only available for individual copings.

Example of multi-axis machining
Multi-axis machining Add. angle Rotation axis	Yes 10 X
The first toolpath (1) is calculated with a tilt of 10 degrees, and the second toolpath (2) with a tilt of -10 degrees.

Clip sintering pins
Yes	Do not machine the optional sintering pins with this job. As a rule, it is enough to machine the sintering pins using only the roughing cycle. This can reduce the machine runtime without affecting quality.
Add. margin line allowance	Allowance to protect the margin line that is added to the value configured in the --> “General setting” > “Margin line thickness” option. Important when finishing zirconium oxide so that the margin line area is not machined any further as it generally has already been fully machined.