1. Highlight: New design + workflow improvement
|
• By reducing the number of icons, the workflow becomes clearer. • The design has been significantly revised. |
|
|
|
2. Highlight: Angled screw channels can be edited
|
|
The following parameters can be assigned to a screw channel.
•The inner and outer bending height over the screw seat area •Machining of conical or parallel walls •Angled channels can be straightened •Straight channels can be angled |
|
|
|
3. Highlight: New part types are detected based on the metadata
|
|
Currently these part types are only recognized by Exocad
•Lower partial framework telescopic and with brackets •Maryland bridge •Reduced abutment crown •Reduced abutment crown bridge •Secondary telescope •Secondary telescope bridge •Thimblebridge •Upper partial framework telescopic and with brackets •Veneer |
|
|
|
4. Highlight: hyperDENT® PowerMilling
|
|
•In this strategy, roughing and finishing are combined in one job. The tool mills the part at full depth. This mainly saves time. •Typical application examples: Zirconator of the company Hufschmied/Ceramic Blanks |
|
|
|
5. Highlight: Lollipop tools support
|
|
•In the following jobs, all tool types (ball/torus/lollipop/shank) can be supported with multi-axis mode switched off. Occlusal side machining 3D Equidistant Flow. |
|
|
|
6. Highlight: Option "Hold tool in upright direction"
|
|
•When the control hook is activated, the tool is held upright as long as possible in 5-axis jobs and only traverses the areas in 5-axis that cannot be reached otherwise.
•This option is available in the following 5-axis and 4-axis jobs: •External single elements (caps and abutments occlusal). •Small cavities (inlays/abutment bases/caps/tooth pockets/benuterdefined areas) •Screw channels and predrilling |
|
|
|
7. Highlight: New option for displaying blank geometries in groups
|
|
•Now blank geometries can be assigned to groups in the blank database (e.g. by prefabs manufacturer, which can be clamped in a common fixture). |
|
|
|
