or 
.The [Queue A (B) Properties] window appears.
.[Cut Sheet after Output]
Select this to cut the media after each job is printed.
Select this to cut the media after each job is printed.
[Use Custom Settings]
Check this option if you want to change the following items as.
Check this option if you want to change the following items as.
[Page Space]
Select this to specify the amount to feed the media after printing.
[Overprint]
Select this to perform overprinting.
Select this to specify the amount to feed the media after printing.
[Overprint]
Select this to perform overprinting.
In order to configure [Feed Calibration Controls], [Other Controls] and [Heater Controls], select how you want to control these options from one of the following:
The following options can be configured only when [Use Custom Settings] is selected.
| Use Default Media Settings | Uses the recommended settings for the media selected in [Media Name] in [Quality Settings]. |
|---|---|
| Use Custom Settings | Uses the settings configured in this window. |
| Use Printer Settings | Uses the settings configured on your printer. |
[Feed Calibration Controls]
When using non-genuine media, you need to configure the feed calibration on your printer or VersaWorks. When configuring in VersaWorks, measure the feed calibration on your printer, and then enter the measured value in [Feed Calibration].
For information on how to measure a feed calibration, refer to the documentation of your printer.
When using non-genuine media, you need to configure the feed calibration on your printer or VersaWorks. When configuring in VersaWorks, measure the feed calibration on your printer, and then enter the measured value in [Feed Calibration].
For information on how to measure a feed calibration, refer to the documentation of your printer.
[Other Controls]
[Vacuum Power]
Configure the intensity of the vacuum to hold the media flat on the platen.
Increase the power when the media often gets curled or buckled. When using soft media, decreasing the power may improve the media feeding.
[Dry Time]
Configure time (in minutes) to wait before printing the next page or perform cutting. For example, when you need the printed surface to be completely dry when performing printing and cutting, you can set the drying time.
[Head Height]
Configure the height of the print head for printing. In general, this setting should not be changed.
Configure the intensity of the vacuum to hold the media flat on the platen.
Increase the power when the media often gets curled or buckled. When using soft media, decreasing the power may improve the media feeding.
[Dry Time]
Configure time (in minutes) to wait before printing the next page or perform cutting. For example, when you need the printed surface to be completely dry when performing printing and cutting, you can set the drying time.
[Head Height]
Configure the height of the print head for printing. In general, this setting should not be changed.
[Heater Controls]
Note
[Pre Heater], [Print Heater], [Dryer]
Select each device to configure the temperature settings of the device.
Deselect to turn off the device when printing.
Select each device to configure the temperature settings of the device.
Deselect to turn off the device when printing.
- Depending on the printer, some settings may not be available.
When using the printer that does not have the dryer temperature control feature, you can turn on/off the dryer by selecting/deselecting [Dryer].
