ROTATE

Stored in Memory	Yes
Factory Default	0deg
Selection Choices	0deg or 90deg

Description
Sets the direction of the coordinate axis for cutting.
When set to 0deg (default value), the origin is set at the lower left of the material.
When set to 90deg, the origin is set at the lower right of the material, and the data is rotated counterclockwise by 90 degrees.
Note that
when 90deg is selected, the coordinate axis changes.

The arrows in the figure indicate the positive directions of X and Y axes.

When set to 0deg


When set to 90deg


If you are using crop marks, be sure to select 0deg.