The Overlap function is used when it is not possible to cut through the material in a single pass, for example, when cutting thick material.

Procedure

Make sure that the material is load to the machine.
  1. Press several times to display the screen shown in the figure.

     

  2. Press several times to display the screen shown in the figure.

  3. Press .
  4. Press several times to display the screen shown in the figure.

  5. Press .
  6. Press to set the number of cuts.

    Setting Range: 1 to 10

    OVERLAP → 2 Normal cut + 2 → 3 cuts are made
  7. Press .

    This setting remains enabled until you disable it. If you do not require it, disable it after use.

    Press the key to return to the screen shown in the figure.

Back Next